25 free CDL Combination Vehicles practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.
1.What is off-tracking?
- When the rear wheels follow a different path than the front wheels in a turn
- When the trailer drifts out of its lane on a straight road
- When the tractor leaves the road onto the shoulder
- When the trailer wheels lock and slide
Show answer
A. When the rear wheels follow a different path than the front wheels in a turn
When a vehicle goes around a corner, the rear wheels follow a different path than the front wheels. This is off-tracking, or cheating.
CDL manual, section 6.1.6.
2.In a rig with more than one trailer, which wheels off-track the most in a turn?
- The tractor's front wheels
- The tractor's rear wheels
- The first trailer's rear wheels
- The last trailer's rear wheels
Show answer
D. The last trailer's rear wheels
Longer vehicles off-track more, and the rear wheels of the last trailer off-track the most.
CDL manual, section 6.1.6.
3.If you cannot finish a turn without entering another traffic lane, when should you turn wide?
- Before you start the turn, by swinging left
- In the middle of the intersection
- As you complete the turn
- Never; wait for the lane to clear
Show answer
C. As you complete the turn
Turn wide as you complete the turn. Swinging wide to the left before the turn lets other drivers pass you on the right.
CDL manual, section 6.1.6.
4.Why should you keep the rear of your vehicle close to the curb when turning right?
- To shorten the turn
- To stop other drivers from passing you on the right
- To protect the trailer tires
- To keep the load from shifting
Show answer
B. To stop other drivers from passing you on the right
Keeping the rear close to the curb stops other drivers from passing you on the right.
CDL manual, section 6.1.6.
5.When backing a trailer, which way do you turn the steering wheel?
- Opposite to the way you would when backing a car
- The same way as when backing a car
- Always to the left
- You do not steer; you use the trailer brakes
Show answer
A. Opposite to the way you would when backing a car
When backing a car, straight truck or bus, you turn the top of the wheel the way you want to go. With a trailer, you turn it the opposite way.
CDL manual, section 6.1.7.
6.If you must back a trailer on a curved path, which way should you back?
- Toward the passenger side
- Toward whichever side is wider
- Straight back, then turn at the end
- Toward the driver's side, so you can see
Show answer
D. Toward the driver's side, so you can see
Try to back in a straight line. If you must back on a curve, back to the driver's side so you can see.
CDL manual, section 6.1.7.
7.While backing a trailer, you see it drift off the proper path. How do you correct it?
- Stop and pull forward to the start
- Turn the top of the wheel away from the drift
- Turn the top of the wheel in the direction of the drift
- Apply the trailer hand brake
Show answer
C. Turn the top of the wheel in the direction of the drift
Correct drift right away by turning the top of the steering wheel in the direction of the drift.
CDL manual, section 6.1.7.
8.What is another name for the trailer hand valve?
- Glad hand
- Trolley valve or Johnson bar
- Cut-out cock
- Relay valve
Show answer
B. Trolley valve or Johnson bar
The trailer hand valve is also called the trolley valve or Johnson bar. It works the trailer brakes.
CDL manual, section 6.2.1.
9.What should the trailer hand valve be used for?
- Only to test the trailer brakes
- Slowing down on long downgrades
- Parking the trailer
- Straightening out a jackknife
Show answer
A. Only to test the trailer brakes
Use the trailer hand valve only to test the trailer brakes. Use the foot brake when driving.
CDL manual, section 6.2.1.
10.Why should you not use the trailer hand valve while driving?
- It wears out the tractor brakes
- It turns off the ABS
- It uses too much air
- It can make the trailer skid
Show answer
D. It can make the trailer skid
Using the hand valve while driving risks a trailer skid. The foot brake sends air to all brakes, with much less risk of a skid or jackknife.
CDL manual, section 6.2.1.
11.Why should you never use the trailer hand valve for parking?
- It locks the tractor wheels too
- It cannot hold a loaded trailer
- The air might leak out and release the brakes
- It drains the trailer air tanks
Show answer
C. The air might leak out and release the brakes
All the air might leak out, unlocking the brakes on trailers without spring brakes. Use the parking brakes, and chocks if the trailer has no spring brakes.
CDL manual, section 6.2.1.
12.What does the tractor protection valve do?
- It keeps the trailer from rolling backward on hills
- It keeps air in the tractor brake system if the trailer breaks away or has a bad leak
- It controls how hard the trailer brakes are applied
- It removes water from the trailer air tanks
Show answer
B. It keeps air in the tractor brake system if the trailer breaks away or has a bad leak
The tractor protection valve keeps air in the tractor or truck brake system if the trailer breaks away or develops a bad leak.
CDL manual, section 6.2.2.
13.At about what air pressure does the tractor protection valve close by itself?
- 5 to 10 psi
- 20 to 45 psi
- 60 to 80 psi
- 100 to 125 psi
Show answer
B. 20 to 45 psi
The tractor protection valve closes automatically when air pressure is low, in the range of 20 to 45 psi.
CDL manual, section 6.2.2.
14.On newer vehicles, what does the trailer air supply control look like?
- A yellow diamond-shaped knob
- A blue round knob
- A lever marked "normal" and "emergency"
- A red eight-sided knob
Show answer
D. A red eight-sided knob
On newer vehicles it is a red eight-sided knob. Older vehicles may have a lever with "normal" and "emergency" positions.
CDL manual, section 6.2.3.
15.What happens when you push in the trailer air supply knob?
- Air is supplied to the trailer
- The trailer emergency brakes come on
- The tractor parking brakes release
- The trailer air tanks drain
Show answer
A. Air is supplied to the trailer
Push the knob in to supply the trailer with air. Pull it out to shut the air off and put on the trailer emergency brakes.
CDL manual, section 6.2.3.
16.What happens when you pull out the trailer air supply knob?
- The trailer air tanks fill faster
- The tractor brakes release
- The air to the trailer shuts off and the trailer emergency brakes come on
- The ABS turns off
Show answer
C. The air to the trailer shuts off and the trailer emergency brakes come on
Pulling the knob out shuts off the trailer's air and puts on the trailer emergency brakes.
CDL manual, section 6.2.3.
17.What controls the air in the service line?
- The trailer air supply knob
- The foot brake or the trailer hand brake
- The governor
- The tractor protection valve
Show answer
B. The foot brake or the trailer hand brake
The service line carries air controlled by the foot brake or the trailer hand brake. Its pressure changes with how hard you apply them.
CDL manual, section 6.2.4.
18.What else is the service air line called?
- The supply line
- The emergency line
- The control line or signal line
- The relay line
Show answer
C. The control line or signal line
The service line is also called the control line or signal line. The emergency line is the one called the supply line.
CDL manual, section 6.2.4.
19.What are the two purposes of the emergency air line?
- It supplies air to the trailer air tanks and controls the trailer emergency brakes
- It powers the trailer lights and the ABS
- It controls the service brakes and the parking brakes on the tractor
- It drains water from the tanks and warns of low pressure
Show answer
A. It supplies air to the trailer air tanks and controls the trailer emergency brakes
The emergency (supply) line fills the trailer air tanks and controls the trailer emergency brakes.
CDL manual, section 6.2.4.
20.What happens if the emergency air line loses pressure?
- Nothing until you press the brake pedal
- The service brakes stop working but nothing else changes
- The trailer air tanks overfill
- The trailer emergency brakes come on and the tractor protection valve closes
Show answer
D. The trailer emergency brakes come on and the tractor protection valve closes
Loss of pressure in the emergency line makes the trailer emergency brakes come on. It also closes the tractor protection valve, so the air supply knob pops out.
CDL manual, section 6.2.4.
21.Air lines and glad hands are often color coded. Which colors are used?
- Emergency line green, service line yellow
- Emergency line red, service line blue
- Emergency line blue, service line red
- Emergency line black, service line white
Show answer
B. Emergency line red, service line blue
Red is used for the emergency (supply) line and blue for the service line.
CDL manual, section 6.2.5.
22.At what angle should glad hand couplers be held when you press their seals together?
- 30 degrees
- 45 degrees
- 90 degrees
- 180 degrees
Show answer
C. 90 degrees
Press the two seals together with the couplers at a 90 degree angle to each other, then turn the glad hand to join and lock them.
CDL manual, section 6.2.5.
23.What happens if you cross the air lines when coupling a trailer with spring brakes?
- Supply air goes to the service line, so the trailer spring brakes will not release
- The trailer brakes work normally
- The tractor brakes stop working
- The tractor protection valve stays open
Show answer
A. Supply air goes to the service line, so the trailer spring brakes will not release
Crossed lines send supply air to the service line instead of charging the trailer tanks, so there is no air to release the spring brakes.
CDL manual, section 6.2.5.
24.What is another name for off-tracking?
- Drifting
- Cheating
- Crowding
- Whipping
Show answer
B. Cheating
When the rear wheels follow a different path than the front wheels in a turn, it is called off-tracking or "cheating".
CDL manual, section 6.1.6.
25.You are backing a trailer and it starts to turn. What must you do with the steering wheel?
- Hold it still until you have stopped
- Turn it farther in the same direction
- Let go of it and let the trailer settle
- Turn it the other way to follow the trailer
Show answer
D. Turn it the other way to follow the trailer
Once the trailer starts to turn, you must turn the wheel the other way to follow the trailer.
CDL manual, section 6.1.7.
All Combination Vehicles practice tests · Next: Practice Test 3 · Review my mistakes
Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.