CDL General Knowledge Practice Test 8

24 free CDL General Knowledge practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.

1.Recapped or retreaded tires are prohibited on:

  1. The front wheels of a bus
  2. The rear wheels of a trailer
  3. Any vehicle under 26,001 pounds
  4. The drive axle of a tractor
Show answer

A. The front wheels of a bus

Re-grooved, recapped, or retreaded tires on the front wheels of a bus are prohibited.

CDL manual, section 2.1.3.

2.During an inspection, rust around the wheel nuts may mean:

  1. The wheel was recently painted
  2. The tire pressure is low
  3. The nuts are loose
  4. The brakes are overheating
Show answer

C. The nuts are loose

Rust around wheel nuts may mean the nuts are loose, so check their tightness. After a tire has been changed, stop a short while later and re-check the nuts.

CDL manual, section 2.1.3.

3.Wheels or rims that have had welding repairs:

  1. Are safe if the weld is painted
  2. Are not safe
  3. Are allowed on trailers only
  4. Must be inspected once a year
Show answer

B. Are not safe

Wheels or rims that have had welding repairs are not safe. Damaged rims, missing clamps, spacers, studs or lugs, and mismatched, bent or cracked lock rings are also dangerous.

CDL manual, section 2.1.3.

4.Your vehicle must carry spare electrical fuses unless it:

  1. Has a fire extinguisher
  2. Is less than 10 years old
  3. Carries reflective triangles
  4. Is equipped with circuit breakers
Show answer

D. Is equipped with circuit breakers

Required emergency equipment includes fire extinguishers, spare electrical fuses (unless the vehicle has circuit breakers), and warning devices for parked vehicles.

CDL manual, section 2.1.3.

5.Why is a broken exhaust system dangerous?

  1. It lowers fuel economy
  2. It can let poison fumes into the cab or sleeper berth
  3. It makes the engine run cold
  4. It drains the battery
Show answer

B. It can let poison fumes into the cab or sleeper berth

A broken exhaust system can let poison fumes into the cab or sleeper berth. Look for loose, broken or missing pipes, mufflers, tailpipes, stacks and mounting parts, and for leaks.

CDL manual, section 2.1.3.

6.With a manual transmission, how do you keep from rolling back when you start?

  1. Partly engage the clutch before you take your right foot off the brake
  2. Release the parking brake first, then press the accelerator
  3. Start in neutral
  4. Let the vehicle roll back slightly, then accelerate hard
Show answer

A. Partly engage the clutch before you take your right foot off the brake

Partly engage the clutch before you take your right foot off the brake. Use the parking brake when needed, and release it only when you have applied enough engine power to keep from rolling back.

CDL manual, section 2.2.1.

7.When pulling a trailer, rough acceleration can:

  1. Improve traction
  2. Cool the brakes
  3. Save fuel
  4. Damage the coupling
Show answer

D. Damage the coupling

Speed up smoothly and gradually. Rough acceleration can cause mechanical damage, and when you pull a trailer it can damage the coupling.

CDL manual, section 2.2.1.

8.Before backing with a helper, what is the most important hand signal to agree on?

  1. Turn left
  2. Speed up
  3. Stop
  4. Turn right
Show answer

C. Stop

The helper should stand near the back of your vehicle where you can see them. Before you begin backing, work out hand signals you both understand, and agree on a signal for "stop".

CDL manual, section 2.2.4.

9.When a retarder is turned on, it applies braking power:

  1. To all wheels equally
  2. To the drive wheels only
  3. To the trailer wheels only
  4. To the steering axle only
Show answer

B. To the drive wheels only

When turned on, retarders apply their braking power to the drive wheels only, whenever you let up on the accelerator pedal all the way.

CDL manual, section 2.3.4.

10.The average driver's reaction time is about:

  1. One-tenth of a second
  2. 3 to 4 seconds
  3. Three-quarters of a second to 1 second
  4. 10 seconds
Show answer

C. Three-quarters of a second to 1 second

Reaction distance is how far you travel before you physically hit the brakes. The average driver has a reaction time of three-quarters of a second to 1 second. At 55 mph that is about 61 feet.

CDL manual, section 2.6.1.

11.If you triple your speed from 20 to 60 mph, your braking distance becomes about:

  1. The same
  2. 3 times longer
  3. 6 times longer
  4. 9 times longer
Show answer

D. 9 times longer

Triple the speed from 20 to 60 mph and the impact and braking distance are 9 times greater. At 60 mph, your stopping distance is greater than the length of a football field.

CDL manual, section 2.6.1.

12.Which statement about empty trucks is true?

  1. They need greater stopping distances because they have less traction
  2. They always stop faster than loaded trucks
  3. Their brakes work best when the truck is empty
  4. They cannot skid
Show answer

A. They need greater stopping distances because they have less traction

The brakes, tires, springs and shock absorbers on heavy vehicles work best when the vehicle is fully loaded. Empty trucks need greater stopping distances because an empty vehicle has less traction.

CDL manual, section 2.6.1.

13.On packed snow, you should reduce your speed by:

  1. About 10 percent
  2. Half or more
  3. One-third
  4. Nothing, if you have chains
Show answer

B. Half or more

Reduce speed by about one-third on a wet road and by half or more on packed snow. On ice, reduce speed to a crawl and stop driving as soon as you can safely do so.

CDL manual, section 2.6.2.

14.When the temperature drops, which part of the road freezes first?

  1. Bridges
  2. Open, sunny stretches
  3. Uphill grades
  4. Streets in town
Show answer

A. Bridges

Bridges freeze before the road does. Be especially careful when the temperature is close to 32 degrees Fahrenheit. Shaded areas also stay icy long after open areas have melted.

CDL manual, section 2.6.2.

15.Black ice is:

  1. Ice mixed with dirt, so it looks black
  2. Ice that forms only at night
  3. Thick ice on gravel roads
  4. A thin, clear layer of ice that makes the road look wet
Show answer

D. A thin, clear layer of ice that makes the road look wet

Black ice is a thin layer clear enough that you can see the road underneath. It makes the road look wet. Any time the temperature is below freezing and the road looks wet, watch out for black ice.

CDL manual, section 2.6.2.

16.Why is the road very slippery right after it starts to rain?

  1. The tires are cold
  2. Rain cools the brakes
  3. Water mixes with oil left on the road
  4. Drivers speed up in the rain
Show answer

C. Water mixes with oil left on the road

Right after it starts to rain, the water mixes with oil left on the road by vehicles, making it very slippery. If the rain continues, it washes the oil away.

CDL manual, section 2.6.2.

17.If your vehicle is hydroplaning, you should:

  1. Release the accelerator and push in the clutch
  2. Brake hard
  3. Speed up to push through the water
  4. Steer sharply toward the shoulder
Show answer

A. Release the accelerator and push in the clutch

Release the accelerator and push in the clutch. This slows the vehicle and lets the wheels turn freely. Do not use the brakes to slow down.

CDL manual, section 2.6.2.

18.Tests have shown that trucks with a high center of gravity can roll over:

  1. Only above 70 mph
  2. At the posted speed limit for a curve
  3. Only when they are empty
  4. Only on wet roads
Show answer

B. At the posted speed limit for a curve

If you take a curve too fast, the tires can lose traction and skid, or keep traction and the vehicle can roll over. Trucks with a high center of gravity can roll over at the posted speed limit for a curve.

CDL manual, section 2.6.3.

19.In heavy traffic, the safest speed is usually:

  1. 10 mph faster than other traffic
  2. The lowest legal speed
  3. The speed of other vehicles, if it is legal and safe
  4. Whatever keeps you on schedule
Show answer

C. The speed of other vehicles, if it is legal and safe

Vehicles going the same direction at the same speed are not likely to run into one another. Drive at the speed of traffic if you can do so without going at an illegal or unsafe speed.

CDL manual, section 2.6.5.

20.What is the number one cause of injury and death in roadway work zones?

  1. Poor lighting
  2. Narrow lanes
  3. Construction equipment
  4. Speeding traffic
Show answer

D. Speeding traffic

Speeding traffic is the number one cause of injury and death in roadway work zones. Obey posted speed limits, watch your speedometer, and slow down even more when a worker is close to the road.

CDL manual, section 2.6.7.

21.If a heavy load is slowing you down going uphill, you should:

  1. Move to the left lane
  2. Stay in the right lane if you can
  3. Turn on your high beams
  4. Pass other slow vehicles as soon as possible
Show answer

B. Stay in the right lane if you can

Heavy vehicles are often tailgated when they can't keep up with traffic, often when going uphill. Stay in the right lane if you can, and don't pass another slow vehicle unless you can get around quickly and safely.

CDL manual, section 2.7.2.

22.Why should you avoid traveling alongside other vehicles?

  1. It wastes fuel
  2. It is illegal on highways
  3. Another driver may change lanes into you, or you may be trapped when you need to change lanes
  4. It makes your mirrors fog up
Show answer

C. Another driver may change lanes into you, or you may be trapped when you need to change lanes

There are two dangers in traveling alongside others: another driver may change lanes suddenly and turn into you, and you may be trapped when you need to change lanes.

CDL manual, section 2.7.3.

23.If your truck cannot make a right turn without swinging into another lane, you should:

  1. Turn wide as you complete the turn, keeping the rear of your vehicle close to the curb
  2. Swing wide to the left before you start the turn
  3. Stop and back up to try again
  4. Make the turn from the left lane
Show answer

A. Turn wide as you complete the turn, keeping the rear of your vehicle close to the curb

Turn wide as you complete the turn and keep the rear close to the curb, so other drivers cannot pass you on the right. Don't turn wide to the left as you start, because a following driver may think you are turning left and try to pass on the right.

CDL manual, section 2.7.6.

24.Compared with a car, when you enter traffic in a large vehicle you may need:

  1. A smaller gap
  2. The same gap
  3. No gap, if you signal early
  4. A much larger gap
Show answer

D. A much larger gap

Because of slow acceleration and the space large vehicles require, you may need a much larger gap to enter traffic than you would in a car. Allow more room if your vehicle is heavily loaded.

CDL manual, section 2.7.7.

All General Knowledge practice tests · Next: Practice Test 9 · Review my mistakes

Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.