24 free CDL General Knowledge practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.
1.If someone else loaded and secured your cargo, who is responsible for inspecting it?
- The shipper only
- The loading dock supervisor only
- You, the driver
- No one, once the trailer is sealed
Show answer
C. You, the driver
Whether or not you load and secure the cargo yourself, you are responsible for inspecting it, recognizing overloads and poor balance, and knowing it is properly secured.
CDL manual, section 3 (introduction).
2.In the CDL manual, axle weight means:
- The weight transmitted to the ground by one axle or one set of axles
- The weight of the axle itself
- The total weight of the loaded vehicle
- The maximum weight a coupling device can pull
Show answer
A. The weight transmitted to the ground by one axle or one set of axles
Axle weight is the weight transmitted to the ground by one axle or one set of axles.
CDL manual, section 3.2.1.
3.Where is a tire's load rating stated?
- Only in the owner's manual
- On the driver's door frame
- On the vehicle's registration card
- On the side of each tire
Show answer
D. On the side of each tire
Tire load is the maximum safe weight a tire can carry at a specified pressure. This rating is stated on the side of each tire.
CDL manual, section 3.2.1.
4.An overloaded truck going down a grade:
- Will stop in a shorter distance
- May gain too much speed
- Is easier to steer
- Needs less braking
Show answer
B. May gain too much speed
Overloaded trucks have to go very slowly on upgrades, and worse, they may gain too much speed on downgrades. Stopping distance increases and brakes can fail when forced to work too hard.
CDL manual, section 3.2.2.
5.Maximum axle weights are often set by a bridge formula. Its purpose is to:
- Set speed limits on bridges
- Decide which trucks need a CDL
- Prevent overloading bridges and roadways
- Measure the height of a load
Show answer
C. Prevent overloading bridges and roadways
A bridge formula permits less maximum axle weight for axles that are closer together, to prevent overloading bridges and roadways.
CDL manual, section 3.2.2.
6.A high center of gravity is most dangerous:
- In curves, or when you have to swerve to avoid a hazard
- When parked on level ground
- When driving slowly in a straight line
- When the engine is idling
Show answer
A. In curves, or when you have to swerve to avoid a hazard
A high center of gravity makes you more likely to tip over. It is most dangerous in curves, or if you have to swerve to avoid a hazard.
CDL manual, section 3.2.3.
7.If cargo weight is shifted too far to the rear, the front (steering) axle may:
- Carry too much weight and wear out quickly
- Lock up when braking
- Cause the drive wheels to grip better
- Be too light to steer safely
Show answer
D. Be too light to steer safely
Under-loaded front axles, caused by shifting weight too far to the rear, can make the steering axle weight too light to steer safely.
CDL manual, section 3.2.4.
8.On a flatbed loaded with a high center of gravity, there is also a greater chance that:
- The trailer brakes will overheat
- The load will shift to the side or fall off
- The tires will lose air pressure
- The engine will overheat
Show answer
B. The load will shift to the side or fall off
Weight loaded with a high center of gravity increases the chance of rollover. On flatbed vehicles, there is also a greater chance the load will shift to the side or fall off.
CDL manual, section 3.2.4.
9.Bracing used to keep cargo from moving goes from:
- The upper part of the cargo to the floor and/or walls of the cargo compartment
- The cargo to the fifth wheel
- The front bumper to the cargo
- The tires to the cargo deck
Show answer
A. The upper part of the cargo to the floor and/or walls of the cargo compartment
Bracing goes from the upper part of the cargo to the floor and/or walls of the cargo compartment to prevent the cargo from moving.
CDL manual, section 3.3.1.
10.What is the minimum number of tie-downs for a 20-foot load?
- None, if it is heavy enough
- One
- Two
- Three
Show answer
C. Two
Cargo should have at least one tie-down for each 10 feet of cargo, and no cargo should have fewer than two. A 20-foot load needs at least two.
CDL manual, section 3.3.2.
11.Why should you watch for a flapping cargo cover while driving?
- It means the cargo is overweight
- It can tear loose, uncover the cargo, and block your view or someone else's
- It shows the load is perfectly secured
- It lowers your fuel use
Show answer
B. It can tear loose, uncover the cargo, and block your view or someone else's
Look at your cargo covers in the mirrors from time to time. A flapping cover can tear loose, uncovering the cargo, and possibly block your view or someone else's.
CDL manual, section 3.3.4.
12.Containerized loads are generally used when freight is:
- Too small to need securing
- Carried only on local streets
- Made of hazardous materials
- Carried part of the way by rail or ship
Show answer
D. Carried part of the way by rail or ship
Containerized loads are generally used when freight is carried part way by rail or ship, with truck delivery at the beginning and/or end of the journey.
CDL manual, section 3.3.5.
13.Even when livestock are bunched together with false bulkheads, special care is needed because:
- Livestock can lean on curves, which shifts the center of gravity
- Livestock always make the trailer lighter
- False bulkheads are not allowed on highways
- Livestock loads never need extra care
Show answer
A. Livestock can lean on curves, which shifts the center of gravity
Livestock can lean on curves. This shifts the center of gravity and makes a rollover more likely.
CDL manual, section 3.4.3.
14.Besides special permits, an oversized load may require:
- A second driver in the cab
- Driving only at night with no lights
- A police escort or pilot vehicles with warning signs or flashing lights
- A hazardous materials endorsement
Show answer
C. A police escort or pilot vehicles with warning signs or flashing lights
Over-length, over-width or overweight loads may need special equipment such as wide load signs and flashing lights, and may require a police escort or pilot vehicles.
CDL manual, section 3.4.4.
15.If you stop to help at an accident you were not involved in, you should park:
- Right next to the damaged vehicles
- In the middle of the road to block traffic
- As close as possible so your lights shine on the scene
- Away from the accident
Show answer
D. Away from the accident
If you are stopping to help, park away from the accident. The area immediately around the accident will be needed for emergency vehicles.
CDL manual, section 2.20.1.
16.If you have a cell phone or CB at an accident scene, when should you call for assistance?
- Only after you have cared for the injured
- Before you get out of your vehicle
- Only after the police arrive
- After you finish moving the vehicles
Show answer
B. Before you get out of your vehicle
If you have a cell phone or CB, call for assistance before you get out of your vehicle. If not, protect the scene first and then phone or send someone to phone the police.
CDL manual, section 2.20.2.
17.When should you move a severely injured person at an accident scene?
- Only if the danger of fire or passing traffic makes it necessary
- Always, so they are more comfortable
- As soon as you arrive
- Only if they ask you to
Show answer
A. Only if the danger of fire or passing traffic makes it necessary
Don't move a severely injured person unless the danger of fire or passing traffic makes it necessary.
CDL manual, section 2.20.3.
18.Two causes of tire fires are:
- New tires and cold weather
- Over-inflated tires and wet roads
- Under-inflated tires and duals that touch
- Tire chains and slow speeds
Show answer
C. Under-inflated tires and duals that touch
Under-inflated tires and dual tires that touch can cause tire fires.
CDL manual, section 2.21.1.
19.If you have an engine fire, you should:
- Keep the engine running to cool it
- Turn off the engine and avoid opening the hood if you can
- Open the hood fully to reach the fire
- Pour water on the battery
Show answer
B. Turn off the engine and avoid opening the hood if you can
With an engine fire, turn off the engine as soon as you can. Don't open the hood if you can avoid it. Shoot foam through louvers, the radiator, or from under the vehicle.
CDL manual, section 2.21.3.
20.If your vehicle catches fire while driving, where should you NOT pull in?
- An open area away from buildings
- An area away from trees and brush
- A spot away from other vehicles
- A service station
Show answer
D. A service station
Get off the road and park in an open area, away from buildings, trees, brush, other vehicles, or anything that might catch fire. Don't pull into a service station.
CDL manual, section 2.21.3.
21.A B:C type fire extinguisher is designed to work on:
- Burning wood, paper and cloth only
- Burning tires only
- Electrical fires and burning liquids
- Hazardous materials fires of every kind
Show answer
C. Electrical fires and burning liquids
The B:C type extinguisher is designed for electrical fires and burning liquids. The A:B:C type also works on burning wood, paper and cloth.
CDL manual, section 2.21.3.
22.When using a fire extinguisher outdoors, you should position yourself:
- Upwind, so the wind carries the extinguisher to the fire
- Downwind, so the smoke blows past you
- As close to the fire as possible
- Directly above the flames
Show answer
A. Upwind, so the wind carries the extinguisher to the fire
Position yourself upwind and let the wind carry the extinguisher to the fire. Stay as far away from the fire as possible.
CDL manual, section 2.21.3.
23.When you are out of the vehicle, where must shipping papers for hazardous materials be kept?
- Locked in the glove box
- In the sleeper berth
- In the cargo area with the hazardous materials
- On the driver's seat
Show answer
D. On the driver's seat
Keep hazardous materials shipping papers in a pouch on the driver's door, in clear view within reach while driving, or on the driver's seat when you are out of the vehicle.
CDL manual, section 2.23.2.
24.A hazardous materials identification number is:
- A license plate number for placarded vehicles
- A four-digit code used by first responders, shown after the letters NA or UN
- The driver's CDL number
- A two-letter code for the hazard class
Show answer
B. A four-digit code used by first responders, shown after the letters NA or UN
Identification numbers are four-digit codes used by first responders to identify hazardous materials. They are preceded by the letters NA or UN.
CDL manual, section 2.23.3.
All General Knowledge practice tests · Next: Practice Test 12 · Review my mistakes
Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.