CDL Air Brakes Practice Test 4

24 free CDL Air Brakes practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.

1.How is the air compressor connected to the engine?

  1. Through the drive shaft
  2. Through gears or a v-belt
  3. Through the transmission
  4. Through the alternator
Show answer

B. Through gears or a v-belt

The air compressor is connected to the engine through gears or a v-belt.

CDL manual, section 5.1.1.

2.The air compressor stops working while you are driving. What does the manual say about the air tanks?

  1. They lose all their air within a few seconds
  2. They release the spring brakes
  3. They hold enough air to use the brakes several times
  4. They refill from the trailer tanks
Show answer

C. They hold enough air to use the brakes several times

The tanks hold enough air to let you use the brakes several times, even if the compressor stops working.

CDL manual, section 5.1.3.

3.How do you open a manually operated air tank drain?

  1. Turn it a quarter turn or pull a cable
  2. Press the brake pedal three times
  3. Open the safety relief valve
  4. Loosen the cap on top of the tank
Show answer

A. Turn it a quarter turn or pull a cable

Manual drains are opened by turning a quarter turn or by pulling a cable. You must drain the tanks yourself at the end of each day.

CDL manual, section 5.1.4.

4.Why do some automatic air tank drains have electric heating devices?

  1. To dry the brake linings
  2. To warm the air before it reaches the brakes
  3. To heat the cab in winter
  4. To keep the drain from freezing in cold weather
Show answer

D. To keep the drain from freezing in cold weather

Automatic drains are available with electric heaters, which help prevent the drain from freezing in cold weather.

CDL manual, section 5.1.4.

5.In cold weather, how often should you check the alcohol container and fill it as needed?

  1. Once a week
  2. Every day
  3. Once a month
  4. Only when the low air warning comes on
Show answer

B. Every day

Check the alcohol container and fill it as necessary every day during cold weather.

CDL manual, section 5.1.5.

6.Where is the safety relief valve installed?

  1. In the last air tank on the trailer
  2. On the brake pedal
  3. In the first tank the compressor pumps air to
  4. Next to the governor in the cab
Show answer

C. In the first tank the compressor pumps air to

The safety relief valve is installed in the first tank the air compressor pumps air to.

CDL manual, section 5.1.6.

7.Besides brake fade, what can make you need more application pressure to hold the same speed?

  1. Brakes out of adjustment, air leaks or mechanical problems
  2. A fuel tank that is filled all the way up
  3. Driving at night with the headlights on
  4. Using a high gear on a long, flat road
Show answer

A. Brakes out of adjustment, air leaks or mechanical problems

Needing more pressure can also be caused by brakes out of adjustment, air leaks or mechanical problems.

CDL manual, section 5.1.10.

8.In a wedge brake, how are the brake shoes pushed against the drum?

  1. An s-shaped cam turns between the shoes
  2. A power screw clamps a rotor
  3. Hydraulic fluid pushes a piston
  4. The push rod drives a wedge between the ends of the shoes
Show answer

D. The push rod drives a wedge between the ends of the shoes

In a wedge brake, the brake chamber push rod pushes a wedge directly between the ends of two brake shoes.

CDL manual, section 5.1.8.

9.About how long does it take air to flow through the lines to the brakes after you push the pedal?

  1. One half second or more
  2. No time at all
  3. About five seconds
  4. About ten seconds
Show answer

A. One half second or more

With air brakes it takes one half second or more for air to flow through the lines. Hydraulic brakes work instantly.

CDL manual, section 5.4.4.

10.What happens to an automatic wig wag when air pressure rises above 55 psi?

  1. It sounds a buzzer
  2. It rises out of your view
  3. It drops into your view
  4. It must be reset by hand
Show answer

B. It rises out of your view

An automatic wig wag rises out of view when pressure goes above 55 psi. A manual reset wig wag must be put back by hand.

CDL manual, section 5.1.11.

11.How does an air brake system turn on the brake lights?

  1. With a switch on the parking brake knob
  2. With a light sensor at the rear
  3. With an electric switch that works by air pressure
  4. With a switch on the governor
Show answer

C. With an electric switch that works by air pressure

An electric switch that works by air pressure turns on the brake lights when you put on the air brakes.

CDL manual, section 5.1.12.

12.On an older vehicle, what does the front brake limiting valve do in the "slippery" position?

  1. Cuts the normal air pressure to the front brakes by half
  2. Turns off the rear brakes
  3. Doubles the air pressure to the front brakes
  4. Turns on the ABS
Show answer

A. Cuts the normal air pressure to the front brakes by half

In the "slippery" position the limiting valve cuts the normal air pressure to the front brakes by half, which reduces stopping power.

CDL manual, section 5.1.13.

13.What have tests shown about braking with the front wheels?

  1. Front brakes should be turned off on wet roads
  2. Front wheels skid easily on any wet road
  3. Front brakes do little to stop a loaded truck
  4. Front wheel skids from braking are not likely even on ice
Show answer

D. Front wheel skids from braking are not likely even on ice

Front wheel braking is good under all conditions. Tests have shown front wheel skids from braking are not likely even on ice.

CDL manual, section 5.1.13.

14.Automatic front wheel limiting valves reduce air to the front brakes except when?

  1. The vehicle is empty or lightly loaded
  2. The road is dry and the tires are new
  3. The vehicle is going slower than 20 mph
  4. The brakes are put on very hard, at 55 psi or more
Show answer

D. The brakes are put on very hard, at 55 psi or more

They reduce air to the front brakes except when the brakes are put on very hard (55 psi or more application pressure). The driver cannot control them.

CDL manual, section 5.1.13.

15.Why must emergency and parking brakes be held on by mechanical force?

  1. Mechanical force works better when hot
  2. Mechanical force is cheaper to repair
  3. Air pressure can eventually leak away
  4. Air pressure is too strong for parking
Show answer

C. Air pressure can eventually leak away

They must be held on by mechanical force because air pressure can eventually leak away.

CDL manual, section 5.1.14.

16.The low air warning light and buzzer first come on while you drive. What should you do?

  1. Stop safely right away, while you can still control the brakes
  2. Keep driving until the spring brakes come on
  3. Pump the brake pedal to build pressure
  4. Speed up to reach the next truck stop
Show answer

A. Stop safely right away, while you can still control the brakes

Do not wait for the spring brakes to come on. Bring the vehicle to a safe stop right away, while you can still control the brakes.

CDL manual, section 5.1.14.

17.What happens if your brakes are not adjusted properly?

  1. Only the parking brakes will stop working when hot
  2. Neither the service nor the spring brakes will work right
  3. Only the service brakes are affected on downgrades
  4. The spring brakes will make up for the lost braking
Show answer

B. Neither the service nor the spring brakes will work right

The braking power of spring brakes depends on the brakes being in adjustment. Out of adjustment, neither system works right.

CDL manual, section 5.1.14.

18.Truck tractors with air brakes must have ABS if they were built on or after what date?

  1. March 1, 1994
  2. March 1, 1996
  3. March 1, 1997
  4. March 1, 1998
Show answer

C. March 1, 1997

Truck tractors with air brakes built on or after March 1, 1997 must have ABS. Other air-braked vehicles must have it from March 1, 1998.

CDL manual, section 5.1.16.

19.How can you find the date of manufacture to tell if your vehicle must have ABS?

  1. Ask the last driver
  2. Look at the odometer
  3. Check the tire sidewalls
  4. Check the certification label
Show answer

D. Check the certification label

Check the certification label for the date of manufacture to determine if your vehicle is equipped with ABS.

CDL manual, section 5.1.16.

20.On older ABS systems, how long might the malfunction lamp stay on after start-up?

  1. Until you drive over 5 mph
  2. Until the engine is warm
  3. For the whole trip
  4. Until you press the brake pedal
Show answer

A. Until you drive over 5 mph

On newer vehicles the lamp goes out quickly after the bulb check. On older systems it could stay on until you drive over 5 mph.

CDL manual, section 5.1.16.

21.When does ABS work?

  1. Every time you press the brake pedal
  2. Only when the parking brake is on
  3. Only above 55 mph
  4. Only when the wheels are about to lock up
Show answer

D. Only when the wheels are about to lock up

ABS is an addition to your normal brakes and only activates when wheels are about to lock up.

CDL manual, section 5.1.16.

22.Why is it risky to adjust an automatic slack adjuster by hand to bring the brakes within limits?

  1. It cancels the warranty on the brake system
  2. It usually hides a mechanical problem instead of fixing it
  3. It makes the wheels lock up during every stop
  4. It is allowed only once a year by federal law
Show answer

B. It usually hides a mechanical problem instead of fixing it

Manual adjustment usually masks a mechanical problem and can give a false sense of security. Use it only as a temporary measure in an emergency.

CDL manual, section 5.3.2.

23.How do you test the service brakes during the air brake check?

  1. Pull the parking brake knob while moving at 20 mph
  2. Pump the brake pedal with the engine off
  3. Move forward at about 5 mph and brake firmly with the pedal
  4. Back up and use the trailer hand valve
Show answer

C. Move forward at about 5 mph and brake firmly with the pedal

Wait for normal pressure, release the parking brake, move forward slowly (about 5 mph) and brake firmly. Note pulling to one side, unusual feel or delayed stopping.

CDL manual, section 5.3.3.

24.On a long downgrade, about how long should each brake application last when you use the proper braking technique?

  1. About 1 second
  2. About 3 seconds
  3. About 10 seconds
  4. About 30 seconds
Show answer

B. About 3 seconds

Apply the brakes just hard enough to feel a definite slowdown, and release when you are about 5 mph below your safe speed. This should last about three seconds.

CDL manual, section 5.4.6.

All Air Brakes practice tests · Review my mistakes

Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.