CDL Combination Vehicles Practice Test 1

25 free CDL Combination Vehicles practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.

1.More than half of truck driver deaths in crashes are the result of what?

  1. Jackknifes
  2. Truck rollovers
  3. Rear-end collisions
  4. Tire blowouts
Show answer

B. Truck rollovers

The manual says more than half of truck driver deaths in crashes come from truck rollovers.

CDL manual, section 6.1.1.

2.Compared with an empty rig, how much more likely is a fully loaded rig to roll over in a crash?

  1. Two times
  2. Five times
  3. Ten times
  4. Twenty times
Show answer

C. Ten times

Fully loaded rigs are ten times more likely to roll over in a crash than empty rigs.

CDL manual, section 6.1.1.

3.What happens when cargo is piled higher in a truck?

  1. The center of gravity moves higher and the truck turns over more easily
  2. The center of gravity moves lower and the truck is more stable
  3. The center of gravity does not change
  4. More weight moves onto the steering axle, which improves steering
Show answer

A. The center of gravity moves higher and the truck turns over more easily

Piling cargo higher raises the center of gravity, so the truck becomes easier to turn over.

CDL manual, section 6.1.1.

4.Which two things help most to prevent a rollover?

  1. Drive faster on ramps and brake hard in turns
  2. Load heavy cargo on top and keep tires firm
  3. Change lanes quickly and use the trailer hand brake
  4. Keep the cargo as low as possible and drive slowly around turns
Show answer

D. Keep the cargo as low as possible and drive slowly around turns

The manual names two things: keep the cargo close to the ground and drive slowly around turns.

CDL manual, section 6.1.1.

5.Why is cargo loaded to one side of a trailer dangerous?

  1. It wears out the tires on that side
  2. It makes the brakes pull to that side
  3. It makes the trailer lean, so a rollover is more likely
  4. It makes the trailer harder to couple
Show answer

C. It makes the trailer lean, so a rollover is more likely

If the load is to one side so it makes the trailer lean, a rollover is more likely. Keep cargo centered and spread out.

CDL manual, section 6.1.1.

6.What causes the "crack-the-whip" effect in trucks with trailers?

  1. Off-tracking
  2. Rearward amplification
  3. Brake lag
  4. Hydroplaning
Show answer

B. Rearward amplification

Rearward amplification causes the crack-the-whip effect, which can turn a trailer over during a quick lane change.

CDL manual, section 6.1.2.

7.A rearward amplification of 2.0 means what?

  1. The rear trailer is twice as likely to turn over as the tractor
  2. The tractor is twice as likely to turn over as the trailer
  3. The rig needs twice the normal stopping distance
  4. The trailer off-tracks twice as far as the tractor
Show answer

A. The rear trailer is twice as likely to turn over as the tractor

A rearward amplification of 2.0 means the rear trailer is twice as likely to turn over as the tractor.

CDL manual, section 6.1.2.

8.What rearward amplification does the manual give for triples?

  1. 1.0
  2. 2.0
  3. 2.5
  4. 3.5
Show answer

D. 3.5

Triples have a rearward amplification of 3.5: the last trailer can roll 3.5 times as easily as a five-axle tractor.

CDL manual, section 6.1.2.

9.If you turn suddenly while pulling doubles, which trailer is most likely to turn over?

  1. The front trailer
  2. The converter dolly
  3. The rear trailer
  4. Both trailers are equally likely
Show answer

C. The rear trailer

Because of rearward amplification, the last trailer is the one most likely to turn over in a sudden move.

CDL manual, section 6.1.2.

10.What following distance does the manual recommend when pulling trailers?

  1. 2 seconds no matter how long the vehicle is
  2. At least 1 second for each 10 feet of vehicle length, plus 1 more second above 40 mph
  3. 1 car length for each 10 mph of speed
  4. At least 1 second for each 20 feet of vehicle length
Show answer

B. At least 1 second for each 10 feet of vehicle length, plus 1 more second above 40 mph

Follow at least 1 second for each 10 feet of vehicle length, plus another second if you are going over 40 mph.

CDL manual, section 6.1.2.

11.When pulling trailers at night, how fast should you drive?

  1. Slowly enough to see obstacles in your headlights in time to change lanes or stop gently
  2. At the speed limit, since trailers have extra lights
  3. Fast enough to keep up with traffic around you
  4. As fast as you would drive in daylight
Show answer

A. Slowly enough to see obstacles in your headlights in time to change lanes or stop gently

At night, drive slowly enough to see obstacles with your headlights before it is too late to change lanes or stop gently.

CDL manual, section 6.1.2.

12.When does a large combination vehicle take longer to stop?

  1. When it is fully loaded
  2. There is no difference
  3. Only on wet roads
  4. When it is empty
Show answer

D. When it is empty

Large combination vehicles take longer to stop when they are empty than when they are fully loaded.

CDL manual, section 6.1.3.

13.Why do lightly loaded combination vehicles lock their wheels so easily?

  1. Their tires are inflated too much
  2. Their brakes are adjusted too loosely
  3. Stiff suspension springs and strong brakes give poor traction
  4. Their trailer brakes come on before the tractor brakes
Show answer

C. Stiff suspension springs and strong brakes give poor traction

When lightly loaded, the very stiff suspension springs and strong brakes give poor traction, so the wheels lock up easily.

CDL manual, section 6.1.3.

14.What is a "bobtail" tractor?

  1. A tractor pulling two short trailers
  2. A tractor without a semitrailer
  3. A tractor with a single rear axle
  4. A tractor with a sleeper cab
Show answer

B. A tractor without a semitrailer

A bobtail is a tractor driving without a semitrailer.

CDL manual, section 6.1.3.

15.How does a bobtail tractor stop compared with a tractor-semitrailer loaded to maximum gross weight?

  1. It takes longer to stop
  2. It stops in about half the distance
  3. It stops in the same distance
  4. It stops more smoothly
Show answer

A. It takes longer to stop

Tests have shown that bobtails can be very hard to stop smoothly and take longer to stop than a fully loaded tractor-semitrailer.

CDL manual, section 6.1.3.

16.Which of these trailers is likely to get stuck on a raised railroad-highway crossing?

  1. A refrigerated van
  2. A tank trailer
  3. A flatbed with a short load
  4. A lowboy or car carrier
Show answer

D. A lowboy or car carrier

Low-slung units such as a lowboy, car carrier, moving van or possum-belly livestock trailer can get stuck on raised crossings.

CDL manual, section 6.1.4.

17.Which setup can get stuck on a raised railroad-highway crossing?

  1. A single-axle tractor pulling a long trailer whose landing gear is set for a tandem-axle tractor
  2. A tandem-axle tractor pulling an empty van trailer
  3. A straight truck with no trailer
  4. A tractor with a sliding fifth wheel set to the middle
Show answer

A. A single-axle tractor pulling a long trailer whose landing gear is set for a tandem-axle tractor

A single-axle tractor pulling a long trailer with its landing gear set for a tandem-axle tractor can get stuck on a raised crossing.

CDL manual, section 6.1.4.

18.If your vehicle gets stuck on railroad tracks, what should you do first?

  1. Stay in the cab and keep trying to drive off
  2. Uncouple the trailer and pull the tractor clear
  3. Get out of the vehicle and away from the tracks
  4. Set out warning triangles on the tracks
Show answer

C. Get out of the vehicle and away from the tracks

Get out of the vehicle and away from the tracks, then call for help using the emergency information at the crossing.

CDL manual, section 6.1.4.

19.When you report a vehicle stuck on a railroad crossing, what is the most useful thing to give?

  1. Your CDL number
  2. The DOT number of the crossing, if posted
  3. The name of your company
  4. The trailer's license plate
Show answer

B. The DOT number of the crossing, if posted

Give the location using landmarks, especially the crossing's DOT number if it is posted. Look for it on signposts or the signal housing.

CDL manual, section 6.1.4.

20.When is a trailer jackknife (trailer skid) most likely?

  1. When the trailer is empty or lightly loaded
  2. When the trailer is fully loaded
  3. When the tractor has no ABS
  4. When driving uphill
Show answer

A. When the trailer is empty or lightly loaded

When trailer wheels lock up, the trailer tends to swing around. This is more likely when the trailer is empty or lightly loaded.

CDL manual, section 6.1.5.

21.What is the earliest and best way to see that a trailer has started to skid?

  1. A warning light on the dash
  2. A pull on the steering wheel
  3. The sound of the tires
  4. Seeing it in your mirrors
Show answer

D. Seeing it in your mirrors

Seeing the skid in your mirrors is the earliest and best way. Check your mirrors any time you brake hard.

CDL manual, section 6.1.5.

22.Your trailer starts to skid because its wheels locked up. What should you do?

  1. Apply the trailer hand brake
  2. Brake harder with the foot brake
  3. Release the brakes to get traction back
  4. Speed up to pull the trailer straight
Show answer

C. Release the brakes to get traction back

Stop using the brake. Releasing the brakes lets the trailer wheels grip the road again, and the trailer starts to follow the tractor.

CDL manual, section 6.1.5.

23.Why should you not use the trailer hand brake to straighten out a jackknifing trailer?

  1. It only works on the tractor brakes
  2. The brakes on the trailer wheels caused the skid in the first place
  3. It drains all the air from the system
  4. It turns off the ABS
Show answer

B. The brakes on the trailer wheels caused the skid in the first place

The trailer brakes caused the skid, so applying them with the hand brake makes it worse.

CDL manual, section 6.1.5.

24.In which vehicles is keeping cargo low even more important?

  1. Combination vehicles, more than straight trucks
  2. Straight trucks, more than combination vehicles
  3. Buses, more than trucks
  4. Empty trailers, more than loaded trailers
Show answer

A. Combination vehicles, more than straight trucks

Keeping cargo low is even more important in combination vehicles than in straight trucks.

CDL manual, section 6.1.1.

25.A lightly loaded combination vehicle locks its wheels under hard braking. What can happen to the tractor?

  1. It stops in a shorter distance
  2. Its brakes cool down
  3. Its ABS turns off
  4. It can jackknife very quickly
Show answer

D. It can jackknife very quickly

When lightly loaded, poor traction makes the wheels lock easily. The trailer can swing out and the tractor can jackknife very quickly.

CDL manual, section 6.1.3.

All Combination Vehicles practice tests · Next: Practice Test 2 · Review my mistakes

Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.