24 free CDL General Knowledge practice questions with answers and explanations. Answer each question, then open “Show answer”. You need at least 80% correct to pass the real test.
1.Which of these is one of the driver's responsibilities for cargo?
- Making sure the cargo does not restrict access to emergency equipment
- Setting the freight rate
- Choosing the shipper's packaging
- Unloading at every stop
Show answer
A. Making sure the cargo does not restrict access to emergency equipment
The driver must inspect the cargo, recognize overloads and poor balance, keep it secured without blocking the view, and make sure it does not restrict access to emergency equipment.
CDL manual, section 3 (introduction).
2.Your cargo must be secured so that it does not block your view:
- Ahead or to the sides
- Only at night
- Only when parked
- View is not a cargo concern
Show answer
A. Ahead or to the sides
Properly secured cargo must not obscure your view ahead or to the sides.
CDL manual, section 3 (introduction).
3.If your cargo requires hazardous materials placards, you also need:
- A hazardous materials endorsement
- A tank vehicle endorsement
- A passenger endorsement
- No extra endorsement
Show answer
A. A hazardous materials endorsement
Cargo that requires hazmat placards also requires a hazardous materials endorsement on your CDL.
CDL manual, section 3 (introduction).
4.In the CDL manual, "tire load" means:
- The maximum safe weight a tire can carry at a specified pressure
- The total weight of the loaded vehicle
- The weight resting on the steering axle
- The lowest pressure a tire may run at
Show answer
A. The maximum safe weight a tire can carry at a specified pressure
Tire load is the maximum safe weight a tire can carry at a specified pressure.
CDL manual, section 3.2.1.
5.Gross vehicle weight rating (GVWR) is:
- The total weight on the drive axles
- The manufacturer's specified loaded weight of a single vehicle
- The weight of the cargo only
- The weight limit set by a bridge formula
Show answer
B. The manufacturer's specified loaded weight of a single vehicle
GVWR is the value the manufacturer specifies as the loaded weight of a single vehicle.
CDL manual, section 3.2.1.
6.A bridge formula permits:
- More axle weight for axles that are closer together
- Less maximum axle weight for axles that are closer together
- The same axle weight regardless of spacing
- Unlimited axle weight at night
Show answer
B. Less maximum axle weight for axles that are closer together
Maximum axle weights are often set by a bridge formula, which permits less weight for axles that are closer together.
CDL manual, section 3.2.2.
7.During bad weather or in the mountains:
- You may exceed legal weights without a permit
- It may not be safe to operate at legal maximum weights
- Weight limits no longer apply
- You should add weight for traction
Show answer
B. It may not be safe to operate at legal maximum weights
In bad weather or in mountains, it may not be safe to drive at legal maximum weights.
CDL manual, section 3.2.2.
8.When loading, the heaviest parts of the cargo should be placed:
- On top of the lightest parts
- Under the lightest parts
- At the very rear of the trailer
- Wherever they fit
Show answer
B. Under the lightest parts
Put the heaviest parts of the cargo under the lightest parts, so the load sits as low as possible.
CDL manual, section 3.2.3.
9.Loading cargo so the vehicle has a high center of gravity:
- Improves braking
- Increases the chance of a rollover
- Reduces tire wear
- Has no effect on handling
Show answer
B. Increases the chance of a rollover
A high center of gravity makes the vehicle more likely to tip over.
CDL manual, section 3.2.4.
10.Too much weight on the steering axle can cause:
- Hard steering
- Drive wheels that spin easily
- Better traction
- Lighter steering
Show answer
A. Hard steering
Too much weight on the steering axle can cause hard steering and can damage the steering axle and tires.
CDL manual, section 3.2.4.
11.Too little weight on the drive axles can cause:
- Hard steering
- Poor traction
- Overheated brakes
- A bridge-formula violation
Show answer
B. Poor traction
Too little weight on the drive axles can cause poor traction, and the drive wheels may spin easily.
CDL manual, section 3.2.4.
12.Blocking placed at the front, back, or sides of a piece of cargo is used to:
- Keep the cargo from sliding
- Keep the cargo dry
- Raise the center of gravity
- Hide the cargo from view
Show answer
A. Keep the cargo from sliding
Blocking is used at the front, back, and/or sides of cargo to keep it from sliding.
CDL manual, section 3.3.1.
13.The aggregate working load limit of a cargo tie-down system must be at least:
- One-quarter of the cargo's weight
- One-half of the cargo's weight
- Equal to the cargo's weight
- Twice the cargo's weight
Show answer
B. One-half of the cargo's weight
The aggregate working load limit of the tie-downs must be at least one-half the weight of the article or group of articles being secured.
CDL manual, section 3.3.2.
14.Cargo should have at least one tie-down for every:
- 5 feet of cargo
- 10 feet of cargo
- 20 feet of cargo
- 25 feet of cargo
Show answer
B. 10 feet of cargo
Use at least one tie-down for each ten feet of cargo.
CDL manual, section 3.3.2.
15.No matter how small the cargo is, it should have at least:
- One tie-down
- Two tie-downs
- Three tie-downs
- Four tie-downs
Show answer
B. Two tie-downs
Even a small piece of cargo should have at least two tie-downs.
CDL manual, section 3.3.2.
16.A header board (front-end structure) is mainly there to:
- Protect you from your cargo in a crash or emergency stop
- Reduce wind drag
- Display hazmat placards
- Hold the spare tire
Show answer
A. Protect you from your cargo in a crash or emergency stop
The header board protects you from your cargo in a crash or emergency stop by blocking the cargo's forward movement.
CDL manual, section 3.3.3.
17.What are the two reasons for covering cargo?
- To protect people from spilled cargo and to protect the cargo from weather
- To hide the cargo and to reduce wind drag
- To avoid inspections and to lower the vehicle's weight
- To keep the load cool and to save fuel
Show answer
A. To protect people from spilled cargo and to protect the cargo from weather
You cover cargo to protect people from spilled cargo and to protect the cargo from weather.
CDL manual, section 3.3.4.
18.While driving, you should check your cargo covers by:
- Looking at them in your mirrors from time to time
- Stopping every 25 miles
- Only checking them before the trip
- Asking other drivers by radio
Show answer
A. Looking at them in your mirrors from time to time
Look at your cargo covers in the mirrors from time to time while driving.
CDL manual, section 3.3.4.
19.You cannot inspect a sealed load, but you should still check that:
- You do not exceed gross weight and axle weight limits
- The seal is opened so you can see the cargo
- The shipper signs your logbook
- Nothing; the shipper is fully responsible
Show answer
A. You do not exceed gross weight and axle weight limits
Sealed loads cannot be inspected, but you should check that you don't exceed gross weight and axle weight limits.
CDL manual, section 3.3.5.
20.Dry bulk tanks need special care because:
- They have a high center of gravity and the load can shift
- They cannot be weighed
- They always carry hazardous materials
- They have no trailer brakes
Show answer
A. They have a high center of gravity and the load can shift
Dry bulk tanks have a high center of gravity and a load that can shift, so be extremely cautious on curves and sharp turns.
CDL manual, section 3.4.1.
21.When hauling hanging meat, particular caution is needed:
- On sharp curves such as on-ramps and off-ramps
- Only while parked
- Only on straight highways
- Only in rain
Show answer
A. On sharp curves such as on-ramps and off-ramps
Hanging meat needs particular caution on sharp curves such as on-ramps and off-ramps. Go slowly.
CDL manual, section 3.4.2.
22.With less than a full load of livestock, you should:
- Use false bulkheads to keep the animals bunched together
- Spread the animals out across the trailer
- Drive faster so the animals stay standing
- Remove all partitions
Show answer
A. Use false bulkheads to keep the animals bunched together
With less than a full load, use false bulkheads to keep livestock bunched together.
CDL manual, section 3.4.3.
23.Over-length, over-width, or overweight loads usually require:
- Special transit permits, with driving often limited to certain times
- Only a hazardous materials endorsement
- Nothing beyond a standard CDL
- A passenger endorsement
Show answer
A. Special transit permits, with driving often limited to certain times
Oversized loads require special transit permits, and driving is usually limited to certain times.
CDL manual, section 3.4.4.
24.Besides the first 50 miles and every 3 hours or 150 miles, when else should you re-check your cargo?
- After every break you take during driving
- Only at the end of the trip
- Only at weigh stations
- Once a week
Show answer
A. After every break you take during driving
Re-check the cargo and its securing devices after every break you take during driving.
CDL manual, section 3.1.
All General Knowledge practice tests ยท Next: Practice Test 5
Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.