CDL Combination Vehicles Practice Test 3

25 free CDL Combination Vehicles practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.

1.You push in the trailer air supply control, but the trailer spring brakes do not release. What should you check?

  1. The trailer tire pressure
  2. The governor setting
  3. The fifth wheel locking jaws
  4. The air-line connections
Show answer

D. The air-line connections

If the spring brakes don't release when you push the air supply control, check the air-line connections. The lines may be crossed.

CDL manual, section 6.2.5.

2.Why use dummy couplers when the air lines are not connected to a trailer?

  1. To keep air pressure in the trailer
  2. To keep water and dirt out of the couplers and lines
  3. To stop the tractor protection valve from closing
  4. To hold the trailer brakes on
Show answer

B. To keep water and dirt out of the couplers and lines

Dummy couplers keep water and dirt from getting into the coupler and the air lines.

CDL manual, section 6.2.5.

3.How often should you drain the trailer air tanks?

  1. Once a week
  2. Once a month
  3. Every day
  4. Only when the automatic drains fail
Show answer

C. Every day

Drain each tank every day. Even with automatic drains, open the drains to make sure.

CDL manual, section 6.2.6.

4.On a set of doubles or triples, which shut-off valves (cut-out cocks) should be closed?

  1. Only the ones at the back of the last trailer
  2. All of them
  3. The ones on the first trailer
  4. None of them
Show answer

A. Only the ones at the back of the last trailer

All shut-off valves should be open except the ones at the back of the last trailer, which must be closed.

CDL manual, section 6.2.7.

5.Why should you use wheel chocks when you park a trailer that has no spring brakes?

  1. The tractor parking brake does not reach the trailer
  2. The trailer hand valve may be bumped
  3. The landing gear may sink
  4. Its emergency brakes hold only until the air in its tank leaks away
Show answer

D. Its emergency brakes hold only until the air in its tank leaks away

Trailers without spring brakes rely on air in the trailer tank. When that air leaks away, there are no brakes.

CDL manual, section 6.2.8.

6.When might you first notice a major leak in the service line?

  1. When you start the engine
  2. When you put on the brakes
  3. When you push in the air supply knob
  4. When you raise the landing gear
Show answer

B. When you put on the brakes

You may not notice a major service-line leak until you try to brake. The leak then lowers tank pressure quickly.

CDL manual, section 6.2.8.

7.Trailers and converter dollies built on or after what date must have ABS?

  1. January 1, 1975
  2. March 1, 1997
  3. March 1, 1998
  4. January 1, 2005
Show answer

C. March 1, 1998

All trailers and converter dollies built on or after March 1, 1998, are required to have ABS.

CDL manual, section 6.3.1.

8.Where is the ABS malfunction lamp on a trailer?

  1. A yellow lamp on the left side, at the front or rear corner
  2. A red lamp in the center of the rear
  3. A green lamp on the right side
  4. There is no lamp on the trailer, only in the cab
Show answer

A. A yellow lamp on the left side, at the front or rear corner

Trailers have yellow ABS malfunction lamps on the left side, on the front or rear corner.

CDL manual, section 6.3.1.

9.How can you tell if an older trailer has ABS?

  1. Check the color of the glad hands
  2. Look for a red knob on the trailer
  3. Count the number of air tanks
  4. Look underneath for the ECU and wheel speed sensor wires
Show answer

D. Look underneath for the ECU and wheel speed sensor wires

On older units, look under the vehicle for the ECU and wheel speed sensor wires coming from the back of the brakes.

CDL manual, section 6.3.1.

10.Only your trailer has ABS, and you start a tractor jackknife. What should you do?

  1. Brake harder
  2. Let up on the brakes, if you can safely, until you regain control
  3. Use the trailer hand valve
  4. Pull out the trailer air supply knob
Show answer

B. Let up on the brakes, if you can safely, until you regain control

If you lose steering control or start a tractor jackknife, let up on the brakes (if you can safely do so) until you gain control.

CDL manual, section 6.3.2.

11.How should you brake a tractor-trailer that has ABS?

  1. Pump the brakes quickly
  2. Brake harder than without ABS
  3. Brake as you always have
  4. Use only the trailer hand valve
Show answer

C. Brake as you always have

Brake as you always have, using only the force needed to stop safely, whether the ABS is on the tractor, the trailer or both.

CDL manual, section 6.3.2.

12.Before coupling, what position should the fifth wheel be in?

  1. Tilted down toward the rear of the tractor, jaws open, safety unlocking handle in the automatic lock position
  2. Level, jaws closed, handle in the open position
  3. Tilted up toward the cab, jaws open
  4. Removed from the tractor
Show answer

A. Tilted down toward the rear of the tractor, jaws open, safety unlocking handle in the automatic lock position

The fifth wheel should be tilted down toward the rear, with the jaws open and the safety unlocking handle in the automatic lock position.

CDL manual, section 6.4.1.

13.Why must the fifth wheel plate be greased?

  1. To keep the kingpin from rusting
  2. To keep water out of the air lines
  3. Friction between tractor and trailer can cause steering problems
  4. To make the landing gear easier to crank
Show answer

C. Friction between tractor and trailer can cause steering problems

Failure to keep the fifth wheel plate lubricated can cause steering problems because of friction between the tractor and trailer.

CDL manual, section 6.4.1.

14.Why should you never back under a trailer at an angle?

  1. The air lines may cross
  2. You may push the trailer sideways and break the landing gear
  3. The kingpin will not lock
  4. The trailer brakes will release
Show answer

B. You may push the trailer sideways and break the landing gear

Backing under at an angle can push the trailer sideways and break the landing gear. Put the tractor directly in front of the trailer.

CDL manual, section 6.4.1.

15.Before you couple, what must be true of the trailer wheels?

  1. They must be raised off the ground
  2. They must be turned slightly
  3. They must be greased
  4. They must be chocked or the spring brakes must be on
Show answer

D. They must be chocked or the spring brakes must be on

Be sure the trailer wheels are chocked or the spring brakes are on before coupling.

CDL manual, section 6.4.1.

16.How high should the trailer be when you back the tractor under it?

  1. Low enough that the tractor raises it slightly
  2. High enough that the tractor does not touch it
  3. Exactly level with the top of the fifth wheel
  4. As high as the landing gear allows
Show answer

A. Low enough that the tractor raises it slightly

The trailer should be low enough that it is raised slightly by the tractor when the tractor backs under it.

CDL manual, section 6.4.1.

17.What may happen if the trailer is too low when you couple?

  1. The trailer may not couple correctly
  2. The tractor may strike and damage the trailer nose
  3. The air lines will cross
  4. The landing gear will collapse
Show answer

B. The tractor may strike and damage the trailer nose

If the trailer is too low, the tractor may strike and damage the trailer nose.

CDL manual, section 6.4.1.

18.What may happen if the trailer is too high when you couple?

  1. The tractor may hit the landing gear
  2. The trailer brakes will not release
  3. It may not couple correctly
  4. The glad hands will disconnect
Show answer

C. It may not couple correctly

If the trailer is too high, it may not couple correctly.

CDL manual, section 6.4.1.

19.After supplying air to the trailer during coupling, why do you shut the engine off?

  1. To save fuel
  2. To let the air tanks cool
  3. To reset the ABS
  4. So you can hear the trailer brakes apply and release
Show answer

D. So you can hear the trailer brakes apply and release

Shut the engine off so you can hear the brakes. You should hear them move when applied and air escape when released.

CDL manual, section 6.4.1.

20.What gear should you use to back the tractor under the trailer?

  1. The lowest reverse gear
  2. The highest reverse gear
  3. Neutral, rolling back
  4. Any reverse gear
Show answer

A. The lowest reverse gear

Use the lowest reverse gear and back slowly, so you don't hit the kingpin too hard.

CDL manual, section 6.4.1.

21.How do you check that the trailer is locked onto the tractor?

  1. Look at the trailer from the cab mirror
  2. Raise the landing gear slightly and pull gently forward with the trailer brakes locked
  3. Drive at highway speed and listen for noise
  4. Release all brakes and back up quickly
Show answer

B. Raise the landing gear slightly and pull gently forward with the trailer brakes locked

Raise the landing gear slightly off the ground, then pull the tractor gently forward while the trailer brakes are still locked.

CDL manual, section 6.4.1.

22.Before you go under the trailer to inspect the coupling, what should you do?

  1. Leave the engine running so the air stays up
  2. Raise the landing gear all the way
  3. Disconnect the air lines
  4. Shut off the engine and take the key with you
Show answer

D. Shut off the engine and take the key with you

Put on the parking brakes, shut off the engine and take the key, so no one moves the truck while you are under it.

CDL manual, section 6.4.1.

23.After coupling, how much space should there be between the upper and lower fifth wheel?

  1. None
  2. About 1 inch
  3. About 2 inches
  4. About 4 inches
Show answer

A. None

There should be no space between the upper and lower fifth wheel.

CDL manual, section 6.4.1.

24.Your rig is stuck on railroad tracks and you are safely away from it. Where can you find emergency contact information for the crossing?

  1. On the signposts or signal housing at the crossing
  2. On the trailer's shipping papers
  3. On the tractor's registration card
  4. In the CDL manual
Show answer

A. On the signposts or signal housing at the crossing

Check the signposts or signal housing at the crossing for emergency notification information, then call 911 or another emergency number.

CDL manual, section 6.1.4.

25.What does the manual say about a trailer that has already swung out of your lane in a skid?

  1. Pulling the trailer hand valve will straighten it
  2. It will straighten out if you brake harder
  3. It is very difficult to prevent a jackknife
  4. It will stop on its own within a few feet
Show answer

C. It is very difficult to prevent a jackknife

Once the trailer swings out of your lane, it is very difficult to prevent a jackknife. Check your mirrors any time you brake hard.

CDL manual, section 6.1.5.

All Combination Vehicles practice tests · Next: Practice Test 4 · Review my mistakes

Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.