25 free CDL Air Brakes practice questions with answers and explanations. Choose an answer to check it right away and read why. You need at least 80% correct to pass the real test.
1.During a normal stop in a vehicle with a manual transmission, when should you push in the clutch?
- As soon as you press the brake pedal
- Before you start braking
- When the engine rpm is down close to idle
- Only after the vehicle has fully stopped
Show answer
C. When the engine rpm is down close to idle
Control the pedal pressure for a smooth stop and wait until the rpm is near idle before pushing the clutch. Once stopped, select a starting gear.
CDL manual, section 5.4.1.
2.Without ABS, what happens when your steering wheels lock up under hard braking?
- The vehicle stops faster and straighter
- You lose steering control
- The spring brakes release
- The trailer brakes take over
Show answer
B. You lose steering control
Locked steering wheels cannot steer the vehicle. Locked wheels on other axles can cause a skid, a jackknife or a spin.
CDL manual, section 5.4.2.
3.How does ABS prevent wheel lockup?
- It pumps the brake pedal for the driver
- It applies the spring brakes
- A computer senses lockup coming and reduces braking pressure to a safe level
- It shifts to a lower gear
Show answer
C. A computer senses lockup coming and reduces braking pressure to a safe level
ABS senses when a wheel is about to lock, lowers the brake pressure at that wheel, and lets you keep control.
CDL manual, section 5.4.2.
4.What can you expect when braking hard with ABS?
- You will always stop in half the distance
- You cannot steer while ABS is working
- The engine brake turns off
- You may not stop faster, but you should be able to steer around an obstacle
Show answer
D. You may not stop faster, but you should be able to steer around an obstacle
ABS may or may not shorten the stop. Its main benefit is steering control and avoiding skids from over-braking.
CDL manual, section 5.4.2.
5.Only the tractor has ABS. What should you watch for while braking?
- The trailer swinging out; let up on the brakes if it is safe
- The tractor front wheels locking
- The ABS lamp on the trailer
- The air pressure rising
Show answer
A. The trailer swinging out; let up on the brakes if it is safe
With tractor-only ABS you keep steering control and are less likely to jackknife, but the trailer can still swing out.
CDL manual, section 5.4.2.
6.Only the trailer has ABS. What is the benefit?
- The tractor cannot jackknife
- The trailer is less likely to swing out
- The tractor steering wheels will never lock
- You can brake harder than normal
Show answer
B. The trailer is less likely to swing out
Trailer ABS reduces trailer swing. If you lose steering control or the tractor starts to jackknife, let up on the brakes when safe until you regain control.
CDL manual, section 5.4.2.
7.How should you brake a tractor-trailer that has ABS?
- Always press the pedal as hard as possible
- Pump the brakes quickly
- The same way as always, using only the force needed to stop safely
- Use only the trailer hand valve
Show answer
C. The same way as always, using only the force needed to stop safely
Brake the same way whether the ABS is on the tractor, the trailer or both. Watch the tractor and trailer and ease off the brakes if needed to stay in control.
CDL manual, section 5.4.2.
8.When can you fully apply the brakes in an emergency stop?
- Whenever the tractor has ABS
- Whenever the trailer has ABS
- Only when the road is dry
- When you always drive a straight truck or combination with working ABS on all axles
Show answer
D. When you always drive a straight truck or combination with working ABS on all axles
This is the one exception to normal braking: with working ABS on every axle, you may fully apply the brakes in an emergency.
CDL manual, section 5.4.2.
9.Your ABS stops working. What should you do?
- Drive normally with your regular brakes and get the ABS serviced soon
- Stop and wait for a tow truck
- Drive only below 15 mph
- Use only the parking brake
Show answer
A. Drive normally with your regular brakes and get the ABS serviced soon
If ABS fails you still have normal brakes. Drive and brake as usual, but have the system repaired soon.
CDL manual, section 5.4.2.
10.What is the controlled braking method?
- Brake fully, release when the wheels lock, and brake again
- Brake as hard as you can without locking the wheels, with very small steering movements
- Use only the parking brake
- Brake lightly for a long time
Show answer
B. Brake as hard as you can without locking the wheels, with very small steering movements
If you need a larger steering correction or the wheels lock, release the brakes, then re-apply them as soon as you can.
CDL manual, section 5.4.3.
11.When stab braking, how long can it take for the wheels to start rolling after you release the brakes?
- Up to one second
- Up to five seconds
- Up to ten seconds
- They roll instantly
Show answer
A. Up to one second
Wait for the wheels to roll before re-applying. If you brake again before they roll, the vehicle will not straighten out.
CDL manual, section 5.4.3.
12.What is brake lag?
- The time it takes you to see a hazard
- The distance a vehicle rolls after the brakes lock
- The time it takes air to flow through the lines so the brakes work after you press the pedal
- The delay before the compressor cuts in
Show answer
C. The time it takes air to flow through the lines so the brakes work after you press the pedal
Hydraulic brakes work instantly, but air brakes need a moment, one half second or more, for the air to reach the brakes.
CDL manual, section 5.4.4.
13.At 55 mph on dry pavement, about how much distance does air brake lag add?
- About 6 feet
- About 32 feet
- About 100 feet
- About 450 feet
Show answer
B. About 32 feet
Brake lag adds about 32 feet at 55 mph, on top of perception, reaction and braking distance.
CDL manual, section 5.4.4.
14.For an average driver at 55 mph with good traction and brakes, what is the total stopping distance of an air-braked vehicle?
- About 150 feet
- About 250 feet
- About 350 feet
- Over 450 feet
Show answer
D. Over 450 feet
Perception, reaction, brake lag and braking distance together add up to over 450 feet at 55 mph.
CDL manual, section 5.4.4.
15.Which of these is part of the total stopping distance for air brakes but NOT for hydraulic brakes?
- Perception distance
- Reaction distance
- Braking distance
- Brake lag distance
Show answer
D. Brake lag distance
Air-brake stopping distance is perception + reaction + brake lag + braking distance. Hydraulic brakes have no brake lag.
CDL manual, section 5.4.4.
16.What causes brake fade?
- Too much heat from overusing the service brakes
- Draining the air tanks too often
- Using the engine brake on downgrades
- Driving with ABS turned on
Show answer
A. Too much heat from overusing the service brakes
Heat changes the lining so it grips less, and the drums expand so the shoes press with less force. Relying on the engine braking effect helps prevent it.
CDL manual, section 5.4.5.
17.Why do brakes out of adjustment make brake fade more likely?
- They use less air pressure
- They make the ABS turn off
- They stop doing their share, so the other brakes overheat and fade
- They cool the drums too much
Show answer
C. They stop doing their share, so the other brakes overheat and fade
Every brake must do its share. When some stop working, the rest overheat. Brakes can go out of adjustment quickly, especially when hot, so check them often.
CDL manual, section 5.4.5.
18.On a long, steep downgrade, what is the role of the service brakes?
- They should do all the braking
- They should not be used at all
- They only supplement the braking effect of the engine
- They should be held on lightly the whole way down
Show answer
C. They only supplement the braking effect of the engine
Get into the proper low gear first. The brakes only add to the engine's braking effect.
CDL manual, section 5.4.6.
19.Your safe speed on a downgrade is 40 mph. Using the proper braking technique, what do you do?
- Brake lightly all the way down at 40 mph
- Brake hard to 20 mph, then coast
- Wait until 45 mph, then brake to 40 mph
- When you reach 40 mph, brake firmly until you slow to about 35 mph, then release
Show answer
D. When you reach 40 mph, brake firmly until you slow to about 35 mph, then release
Apply the brakes hard enough for a definite slowdown, release about 5 mph below the safe speed (about three seconds), and repeat when you are back at the safe speed.
CDL manual, section 5.4.6.
20.Why does a heavily loaded vehicle take a long distance to stop when the spring brakes come on?
- The spring brakes do not work on all axles
- The spring brakes only work above 55 psi
- The ABS turns off
- The engine brake stops working
Show answer
A. The spring brakes do not work on all axles
Spring brakes are not on every axle. It is much safer to stop while enough air remains to use the foot brake.
CDL manual, section 5.4.7.
21.What can happen to a lightly loaded vehicle on a slippery road when the spring brakes come on?
- It will stop in a shorter distance than normal
- It may skid out of control
- Nothing, spring brakes are safe on any road
- The spring brakes will release on their own
Show answer
B. It may skid out of control
On light loads or slippery roads, sudden spring brake application can cause a skid. Stop as soon as the low air warning comes on.
CDL manual, section 5.4.7.
22.On older vehicles, what might the parking brake control look like?
- A yellow diamond-shaped knob only
- A red triangle button
- A round blue knob or a lever
- A foot pedal on the floor
Show answer
C. A round blue knob or a lever
Newer vehicles use a yellow diamond knob labeled "parking brakes". Older ones may use a round blue knob or a lever.
CDL manual, section 5.4.8.
23.When should you NOT use the parking brakes?
- When you park on a hill
- When you park overnight
- When the engine is off
- When the brakes are very hot or very wet in freezing temperatures
Show answer
D. When the brakes are very hot or very wet in freezing temperatures
Hot brakes can be damaged by the parking brake, and wet brakes can freeze in place. Use wheel chocks on a level surface instead.
CDL manual, section 5.4.8.
24.Your brakes are very wet and the temperature is below freezing. How can you dry them?
- Use the brakes lightly while driving in a low gear
- Set the parking brake and wait
- Spray them with alcohol
- Drive fast without braking
Show answer
A. Use the brakes lightly while driving in a low gear
Light braking in a low gear heats and dries the brakes. Let hot brakes cool before you use the parking brake.
CDL manual, section 5.4.8.
25.You will be away from your vehicle for only a few minutes. What must you do?
- Nothing, if the engine is running
- Apply the parking brakes or chock the wheels
- Leave it in neutral
- Turn on the four-way flashers only
Show answer
B. Apply the parking brakes or chock the wheels
Never leave a vehicle unattended without the parking brakes on or the wheels chocked. It could roll away and cause injury and damage.
CDL manual, section 5.4.8.
All Air Brakes practice tests · Next: Practice Test 4 · Review my mistakes
Questions written by CDL Quiz Prep and checked against the CDL manual (November 2026). Manuals can differ slightly by state. Found a mistake? Report an error.